Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Gate Repair in Crandall, TX | Ironworks Gate Co.
If your Ghost Controls gate opener is grinding, reversing halfway, or refusing to respond in Crandall, the problem usually starts underground, not in the motor. We provide Gate Repair - Crandall and independent Ghost Controls service across Crandall’s acreage lots and subdivisions, and the defining difference here is the Blackland Prairie clay under your gate posts. Call (936) 715-3043 and we’ll tell you straight what’s actually happening, then fix it so it stays fixed.
We’re Ironworks Gate Co., and we’ve worked on Ghost Controls openers in Crandall long enough to know which failures repeat on which lots. We’re not a manufacturer-authorized dealer. We’re an independent Ghost Controls sales & service shop, which means we diagnose the way a field tech should: by looking at the post, the hinges, the arm, and the board, in that order. Victor Salinas, our owner, grew up in Rockwall and has spent nearly three decades doing gate work across this county. He’ll tell you the same thing we tell every Crandall homeowner who calls: “If the gate doesn’t work right, nothing else about it matters.”
Why Crandall Residents Choose Us for Ghost Controls Service
Most gate companies can swap a motor. Few can reset a post that’s heaved four inches out of plumb, re-weld a cracked hinge, re-aim a limit switch, and re-test the whole system before they leave. That’s the work Crandall gates actually need, and it’s the work we do every week.
We’re trained and equipped on nine gate-automation brands, Ghost Controls included, so the correct fix happens on the first visit. Our technicians are background-checked and uniformed, working on your property the way they’d work on their own mother’s. Every job carries the 90-Day Done Right Promise in writing. If it’s not right, we come back and make it right. No paperwork, no arguing, no exceptions. We’ve been at this for over 42 years, and we plan to be here in Crandall for another forty.
We serve the whole Crandall service area, from the US-175 corridor out to the acreage communities east of town.
Common Ghost Controls Gate Repair Problems We Solve in Crandall
- Stripped actuator gears from tilted posts. When a Ghost Controls TSS1 or TDS2 arm grinds and the motor sounds strained, it’s rarely the motor failing. It’s the post leaning 3 to 6 inches off vertical, binding the gate, and forcing the arm’s internal gear to chew itself up. We reset the post first, then replace the arm.
- Phantom AXS1 sensor detections. The AXS1 vehicle sensor works off a buried probe. Crandall’s clay shifts when it wets and dries, and that movement pulls the probe out of alignment. Your gate opens for no one, or won’t open for your car. We re-trench, re-align, and re-test the sensor loop.
- Burnt control board relays. TSS1 and TDS2 boards fail when a binding hinge or misaligned track makes the motor stall repeatedly. Homeowners often blame the motor. Our techs test the board’s relay contacts first, because that’s where the heat damage piles up.
- Solar TSS1XP low-voltage faults. Crandall’s wet spring stretches mean days of cloud on shaded acreage lots. The battery drains, voltage drops, and the gate opens halfway before reversing. We check the panel angle, the battery condition, and the charging circuit, then make the fix that fits your lot’s actual sun exposure.
- Hinges and welds failing from frame stress. Expansive clay doesn’t just move posts. It twists the gate frame itself over time, especially on the older DIY-installed gates from Crandall’s 2010s building boom. Worn hinges and popped welds follow. We repair the metal and the geometry together.
Ghost Controls Service in Crandall: What Local Conditions Mean for Your Equipment
Here’s the thing most generic gate repair pages won’t tell you. Crandall sits on the Blackland Prairie, a band of heavy expansive clay that swells hard after rain and cracks deep during summer drought. Every cycle, the soil under your gate posts moves. Posts tilt. Footings crack. Gate alignment goes out of plumb, and the opener takes the punishment. The post-2010 acreage subdivisions along U.S. 175 were built fast, and many original Ghost Controls installations used shallow footings that couldn’t handle Kaufman County’s shrink-swell cycle. We routinely find posts that have moved 3 to 6 inches out of vertical on those lots. The actuator arm strips its gears long before the motor itself gives out, which means the right repair always starts with the post, not a new opener. Our tech responded to a Ghost Controls TSS1 on a Windmill Farms acreage lot where the gate wouldn’t close fully. The post had heaved four inches out of plumb, the arm’s internal gear was stripped from repeated stalls. We dug out the old footing, re-set the post on a deeper pier, installed an OEM replacement arm, and re-aimed the limit switches. The gate cycles silently now. That’s the standard of repair Crandall’s soil demands.
Ghost Controls Models & Products We Service in Crandall
We service the full Ghost Controls residential lineup: the TSS1 single gate opener, TDS2 dual gate opener, TSS1XP solar opener, and AXS1 vehicle sensor. We also offer our Gate Installation in Crandall, and keep OEM Ghost Controls arms, control boards, limit switches, and sensors on hand for fast Crandall turnaround. For batteries and solar panels, we’ll use quality aftermarket components when they match the unit’s voltage and cost less than OEM, because that’s the honest trade. Our position on repair versus replace is simple: fix the root cause first. Most Ghost Controls units in Crandall fail from frame stress and soil movement, not internal defects. Replace the opener only when the root cause is fixed, or you’ll be buying another opener in three years.
Ghost Controls Service Pricing in Crandall
Ghost Controls repair in Crandall typically runs between $180 and $450 depending on what actually failed. A post reset with new concrete runs $250 to $600 when the footing must be dug out and re-poured. Actuator arm replacement with OEM parts lands between $180 and $400 installed. Control board replacement ranges $150 to $350. Solar panel and battery work typically runs $120 to $375. You’ll know the exact price before we start, because we quote every job upfront and settle it before a single bolt is turned. Estimates are free. Call (936) 715-3043 and we’ll come look at your gate.
Serving Crandall, TX - Our Local Coverage Area
We’re based in the Crandall area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Ghost Controls Gate Repair in Crandall
Because your post has moved. Crandall’s expansive clay heaves the post out of vertical, the gate binds, and the actuator’s internal gear strips under repeated stall torque. It happens on 5 to 10 year old installations in this area more than any other failure we see. The real fix is a post reset on a deeper footing, not another arm on a tilting post. Call (936) 715-3043 and we’ll measure the tilt and tell you exactly what’s moving.
Yes, but the panel has to be placed where it actually catches sun, and on heavily shaded acreage lots that often means a remote panel mount or a larger panel than the factory kit provides. We’ll assess your lot’s sun exposure, size the panel to your battery, and wire it correctly so the gate doesn’t drop voltage and reverse halfway after a cloudy week.
No, it’s clay movement. The AXS1 sensor probe sits in the ground, and when the soil shifts, the probe moves and the sensor’s field changes. That causes false detections or fails to detect your car entirely. It’s a known issue on expansive clay, and it’s fixable by re-trenching and re-aligning the probe. Call us and we’ll sort it.
That’s usually a limit switch or force setting issue on the secondary leaf, made worse by a hinge that’s binding or a post that’s shifted. Crandall’s soil movement pushes the second leaf out of alignment, so the opener senses resistance and reverses. We re-align the leaf, check the hinges, and re-aim the limit switches on both operators before we touch the board.
Get the posts set right once, on a properly deep engineered footing, and have the gate realigned seasonally. That stops the cycle of arm and gear damage before it starts. Our $89 Seasonal Tune-Up covers hinge lubrication, limit re-aiming, sensor alignment, and post inspection before the soil does its worst. Call (936) 715-3043 to schedule one.
Service Areas Near Crandall
We run Ghost Controls service throughout the Crandall area and into Ghost Controls service in Fate, Ghost Controls service in Rockwall, Forney, Heath, and Greenville. If you’re on acreage east of US-175 or in one of the newer subdivisions off the corridor, we’re already working near you.
Book Your Ghost Controls Service in Crandall Today
Call (936) 715-3043 and a live person answers, day or night. We’ll schedule your estimate, show up when we say, and put the price in writing before any work starts. Done right, and backed in writing.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Crandall since 1984.