Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.





Ghost Controls Gate Access Control in Rockwall: What to Know First
Ghost Controls gate access control repair in Rockwall is work we handle regularly, and most jobs are completed in a single visit. As an independent Ghost Controls service provider, we repair keypads, remotes, phone entry systems, card readers, and video intercoms on Ghost Controls operators across Rockwall County, typically for between $185 and $420 depending on what failed. You’ll get a firm price before any work begins, and every repair is covered by our 90-Day Done Right Promise in writing.

This page is for Rockwall homeowners whose Ghost Controls gate opener has stopped responding to the keypad, remote, or intercom. If that’s you, call (936) 715-3043 and a live person answers, any hour, any day.
How Ghost Controls Products Fail - and How We Fix Them
Ghost Controls makes a solid residential opener at a fair price, and we see them all over Rockwall driveways. But their access control components have failure patterns we’ve learned to spot from the driveway before we even open the panel. Here’s what actually goes wrong:
- AXPB and AXXB keypad dead zones. The membrane keypads on Ghost Controls entry systems wear unevenly here in Rockwall, where summer heat bakes the keypad face for months on end. The “1” and “3” keys usually go first because those are the most-used digits in local gate codes. We replace the keypad with an OEM unit when the operator is under warranty, and use a sealed aftermarket equivalent on older models to keep the repair cost down without trading away reliability.
- Remote receivers losing programmed codes after brownouts. Rockwall sees enough storm activity to interrupt power a few times each year, and Ghost Controls receivers occasionally dump their memory when the power comes back dirty. The symptom is a remote that worked yesterday and does nothing today, while the keypad still functions. We reprogram, verify the signal strength, and add a surge-rated transformer when the panel shows signs of repeated voltage spikes.
- Wireless intercom lag on the Ghost Controls line. The video intercom kits Ghost Controls sells through retailers are decent, but the wireless variants can lag badly when the gate is more than 100 feet from the house or when a Rockwall limestone wall sits between the two antennas. We diagnose whether the fix is a wired ethernet run, a repeater, or a different mounting position, and we’ll tell you straight if a hardwired option is the only way to make it reliable.
- Exit wand and loop detector false triggers. On Ghost Controls systems with free-exit vehicle detection, the most common Rockwall failure is a buried loop wire breaking after a few years of clay soil shifting with our wet-dry cycles. The gate opens fine from the keypad but won’t open when you drive up to leave. We locate the break, splice it properly with waterproof connectors, and retune the detector. No guesswork, no replacing parts that don’t need replacing.
- Battery backup confusion after a storm. Some Ghost Controls openers run their access board on a small backup battery. When that battery is dying, the gate itself works but the keypad backlight flickers or the panel reads codes intermittently. We test the battery under load and replace it during the same visit when needed, so you’re not chasing a keypad problem that’s actually a 12-volt battery failing quietly inside the box.
Our Ghost Controls Gate Access Control Process
When you call (936) 715-3043, the job starts right then. A live person takes the call, asks what the gate is doing, and schedules a window the same day or next. Here’s how a typical Ghost Controls gate access control repair goes from there:
- 1
We arrive and listen first. Before we touch anything, we ask when the problem started, what the gate did differently, and whether anyone recently changed a code or moved a control box.
- 2
We test the whole chain. Keypad, remote frequency, intercom signal, wiring connections, power supply. Ghost Controls failures often look like a keypad problem and turn out to be a transformer or a wire, and we don’t replace parts until we know which one it is.
- 3
We quote before turning a bolt. Once the failure is confirmed, you get a firm price for the repair. If it’s under $250, remember the standing offer: $50 off any repair over $250. The price is agreed on before work starts, no exceptions.
- 4
We use OEM parts where it matters most. For warranty-covered operators, we use Ghost Controls OEM components so the warranty stays intact. For out-of-warranty units, we’ll offer a quality aftermarket option when it saves you money without shortening the life of the repair.
- 5
We test and retest. Every code, every remote, every sensor, the gate travel, the force settings. We run it through full cycles until it behaves the way it should.
- 6
We leave it right and put it in writing. You get the 90-Day Done Right Promise on every job. If it isn’t right, we come back and make it right. No paperwork, no arguing.
What Ghost Controls Gate Access Control Costs in Rockwall
Most Ghost Controls access control repairs in Rockwall fall into predictable ranges, and we want you to know them before you call:
| Repair Scenario | Typical Cost Range |
|---|---|
| Keypad replacement (AXPB/AXXB style) | $185 - $285 |
| Remote programming or receiver board repair | $120 - $220 |
| Exit loop or wand sensor repair | $190 - $310 |
| Video intercom repair or wiring fix | $220 - $420 |
| Full access board replacement | $340 - $520 |
What moves the price is parts cost, how much wire is buried between the house and the gate, and whether the operator is old enough that we’re working around rusted mounting hardware. Call (936) 715-3043 for an exact quote. Estimates are free, and the price is locked before work starts.
Why Rockwall Homeowners Call Ironworks Gate Co. for Ghost Controls Work
Victor Salinas grew up near the old downtown square in Rockwall, and he’s been fixing gates across this county for the better part of three decades. We’re a gate company, not a general handyman service. Ghost Controls is one of nine opener brands our technicians are trained on, which means when a Ghost Controls board is beyond economical repair, we can tell you honestly whether a LiftMaster, Mighty Mule, or DoorKing operator makes more sense for your gate, your wiring, and your budget. We’re not pushing a brand. We’re fixing a gate.

Every job comes with the 90-Day Done Right Promise. Live people answer our phones 24 hours a day. Our technicians are background-checked, uniformed, and they work in your driveway the way they’d work in their own mother’s. If the gate doesn’t work right, nothing else about it matters. That’s the standard here.
FAQs
Yes. We use OEM Ghost Controls parts on warranty-covered operators so the manufacturer warranty stays intact, and we document the work properly. As an independent service provider, we don’t process warranty claims for you, but we’ll give you everything you need to file one cleanly.
Most Rockwall calls get a same-day or next-day appointment. Call (936) 715-3043 and we’ll give you a straight answer on when we can be there, not a guess.
An access control board replacement runs $340 to $520 and often makes sense on openers under ten years old. If the operator motor or gearbox is also failing, we’ll tell you that straight and quote both paths so you can decide with real numbers in front of you.
We use OEM Ghost Controls parts whenever the operator is under warranty or when an aftermarket part wouldn’t hold up. On out-of-warranty units, we’ll offer a quality aftermarket component where it saves money without cutting the repair’s service life. You always know which one you’re paying for before we start.
Yes. You get a firm, written price before any work begins. No surprises on the bill, no invoice bigger than the quote, every time.
If your Ghost Controls gate access control is acting up in Rockwall, call (936) 715-3043. We’ll answer, we’ll show up, and we’ll fix it right the first time.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Rockwall and nearby areas.
Before
After
Before
After
Before
After