Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterLinear Gate Motor & Opener in Rockwall: What to Know First
Linear gate motor and opener repair in Rockwall typically runs $220 to $410 for a service call and standard repair, while a full motor replacement lands between $850 and $1,600 depending on the model and the condition of the existing arms and brackets. Most Linear repairs we handle are completed in a single visit, and we quote the price before any work starts so there are no surprises on the bill. If you own a Linear opener that’s grinding, stalling, or not responding, call (936) 715-3043 and a live person answers, day or night.
This page is for Rockwall homeowners with a Linear gate motor or opener already on the driveway, or those considering one for a new install. We service every Linear residential line we encounter in Rockwall, Fate, Heath, McLendon-Chisholm, and the rest of Rockwall County, and we carry the parts that fail most often on these units so we’re not driving back and forth to a supply house on your dime.
How Linear Products Fail - and How We Fix Them
Linear openers are workhorses when they’re installed right, but after a decade or more of Texas weather, certain problems show up on a regular basis. These are the failure modes we see most often on Linear gate motors and openers in Rockwall:
- LDO series intermittent operation: The Linear LDO family, common on residential swing gates in neighborhoods like Chandlers Landing and The Shores, has a known weak point at the limit switch wiring. Heat cycles crack the wire insulation inside the arm, and the gate starts stopping three feet short of closed or swinging past the post. Our fix is a full limit circuit inspection, connector replacement, and re-calibration so the gate seats firmly against the stops every single time.
- APeX board logic lockouts: The APeX control board is a good board until it’s not. After a power flicker, these boards sometimes lock into a fault state and refuse to respond to the remote or keypad. A lot of companies throw a new board at it. We’ve found that a hard reset with the proper sequence clears roughly half of them, and when it doesn’t, we replace it with either a factory-recommended board or a warrantied aftermarket unit, depending on your budget.
- Mighty Mule and Linear crossover confusion: Linear bought Mighty Mule years ago, and we still get calls from Rockwall homeowners who have a Mighty Mule badge on the arm but a Linear control board inside. That matters because the troubleshooting steps and parts are different. If your opener says Mighty Mule but acts like a Linear, that’s why. We diagnose by the board revision, not the sticker on the cover.
- Gearbox grinding on slide motors: Linear slide motors, especially the SL series used on Ranch-style gates in developments along John King Boulevard, wear their worm gears faster in Rockwall’s heat. The grease breaks down, the gear runs dry, and you hear a grind that turns into a stall. We open the gearbox, inspect the gear teeth, and either re-grease with a high-temp formulation or replace the gear set before the motor burns out trying to push a dry box.
- Receiver range loss after storms: Linear receivers are generally solid, but the older 318 MHz units fade after repeated lightning storms in this area. The gate works fine from the keypad at the post but won’t open from the car parked fifty feet back. That’s a receiver sensitivity issue, not a remote battery issue. We test the actual signal strength with a meter and replace the receiver or upgrade to a longer-range unit when the numbers say it’s time.
Our Linear Gate Motor & Opener Process
Every Linear job we do in Rockwall follows the same steps, whether it’s a repair, a motor swap, or a full opener replacement. The process exists so you know what to expect before we touch the gate:
- 1
You call (936) 715-3043. A live person answers and takes down what the gate is doing, what brand and model is on it if you know, and when you need us there.
- 2
We arrive, we listen, we test. Our technician checks the full system: motor, board, receiver, limit switches, arms, hinges, and power supply. On a Linear job, we pay special attention to the limit circuit and the gearbox, because that’s where most Rockwall failures live.
- 3
We give you a written price. The number we quote is the number you pay. We explain what needs fixing, what can wait, and what the honest repair-versus-replace line is for your unit. No pressure, no upselling.
- 4
We do the work. OEM Linear parts when warranty or age calls for it, quality aftermarket when it saves you money without cutting corners. Either way, we tell you which one you’re getting and why.
- 5
We test the gate like we’ve never seen it before. Full open and close cycles under load, safety edge checks, obstruction reversal, remote range, keypad code entry. The gate closes like the day it was hung, or we keep working.
- 6
We walk you through it and back it in writing. We show you what we did, what to watch for, and we leave you with the 90-Day Done Right Promise on every job. Done right, and backed in writing.
What Linear Gate Motor & Opener Costs in Rockwall
We quote each Linear job after we see the gate, but here are honest ranges for the work we do most in Rockwall:
- Service call and diagnosis: $75 to $115, waived when you approve the repair.
- Limit switch replacement and re-calibration: $180 to $260.
- Control board replacement: $280 to $510, depending on board revision and OEM versus aftermarket.
- Gearbox repair or gear set replacement: $240 to $420.
- Full Linear motor replacement (arm and motor): $850 to $1,600, model-dependent.
- Complete new Linear swing opener system with two remotes and keypad: $1,400 to $2,400 installed.
What moves the price is parts. A proprietary OEM Linear arm costs more than an aftermarket unit, and on a gate that’s fifteen years old, the smarter money is sometimes a full opener swap rather than nursing a tired motor. We’ll tell you straight which way to go, and the estimate is free. Call (936) 715-3043 and we’ll come look at your gate and give you a written number.
Why Rockwall Homeowners Call Ironworks Gate Co. for Linear Work
Ironworks Gate Co. has been doing gate work in Rockwall County for over 42 years, since 1984, and we’ve seen every Linear model that’s ever been bolted to a driveway here. We’re an independent Linear service provider, which means we don’t answer to a manufacturer’s parts schedule. We answer to the homeowner standing next to us, and that’s the way Victor Salinas has run this company from the start.
We carry Linear parts on the truck so we’re not making you wait on a supply run, and we work on nine major opener brands, LiftMaster, FAAC, BFT, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule included. That matters when a Rockwall home has a Linear opener on the driveway gate and something else on the pedestrian gate. One visit, both gates covered, and every job backed by the 90-Day Done Right Promise in writing. If the gate doesn’t work right, nothing else about it matters.
FAQs
If your Linear opener is still under the manufacturer’s warranty, we use OEM Linear parts to keep that warranty intact. On older units where the warranty has long expired, we offer a quality aftermarket option when it saves you money without cutting corners, and we tell you which one you’re getting before the work starts. Call (936) 715-3043 and we’ll check your model’s warranty status on the spot.
We keep same-day appointments available for Rockwall repairs, and emergency call-outs are covered 24/7 by a live person on the phone, not a voicemail. A dead gate is a security issue as much as an inconvenience, so we treat it with that urgency. Most Linear repairs we complete in one visit.
The rule of thumb we use is the cost of repair times three against the cost of a new opener. If fixing it costs more than a third of replacing it, and the unit is over ten years old, replacement usually makes more sense. We’ll give you real numbers for both options, and you decide with a written price on each.
Yes. We retrofit Linear swing and slide openers onto existing gates all over Rockwall, including older iron gates. We check the gate’s weight, hinge wear, and post integrity before we recommend a specific Linear model, because an opener can only do its job as well as the gate it’s pushing.
Yes, and in Rockwall we recommend it. Power flickers and storm outages are common here, and a Linear opener without battery backup leaves your gate dead until the power returns. We install battery backup kits on existing Linear openers and include them as an option on new installs, so the gate keeps working when the lights go out. Call (936) 715-3043 for a free estimate on adding a battery backup to your Linear opener.
Contact Ironworks Gate Co. for Linear Gate Motor & Opener in Rockwall
If your Linear gate motor is grinding, stalling, or refusing to open, call (936) 715-3043 right now. A live person answers, day or night, and we’ll schedule a time that works for you. The estimate is free, the price is quoted before work begins, and every job is backed by the 90-Day Done Right Promise. We’ve been serving Rockwall for over 42 years, and we answer the phone like it.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Rockwall and nearby areas.